Note: If the camera IP Address can not be found by the search tool, please connect the internet cableĬhecking the WIFI signal connection status If correct, just go back to select “Apply”, then disconnect the network cable. Make sure that all parameters are the same like in your router, enter the WIFI network key.Ĭlick on “Check”, after 30 seconds, the notification will show you if the WIFI settings are successful. Search for the WIFI signals and choose the desired SSID. Refresh the webpage and login again, the camera video will be displayed as belowīutton to access the “Wireless settings”. Note: If the OCX already has been installed you may login directly. (It supports 6 visitors watching online at the same time) (Please change the account user name and password for safety later)Īfter entering the correct user name and password, the Login screen will be displayed. Note: Both the username and password are “admin” In your default browser a login screen like shown below will be displayed: Note: If the Search Tool issues the message "Subnet mask does not match, please clickĭouble click the camera IP address in the search tool. Open the File “Search Tool”, Copy the “Search Tool” to the desktop and launch it.Īfter the hardware is connected properly, launch the search tool, and the IP address of the camera will be Open the File "Browser view" Open "HW”, click on “OCX setup” - “Next” - “Install” - “Finish”Ģ. Insert the CD and install the following software:ġ. Note: For the first time use of IP Camera, please refer to the procedures above.Ĭonnect the camera with Internet cable to the router, and with the power cord to the mains, like shown Note: Some models don’t have a separate antenna.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |